Your home water supply is not safe unless you have a water softener in place. It keeps your water soft so that it can be used for cooking and bathing. What do you need to know about water softeners? Here are some tips for you to consider.

A water softener works by using an ion-exchange method. In a water softener, water is circulated down through the resin bed where it is softened. The water ions are exchanged with the sodium ions in the salt resin bed, thus ridding the water of its salty coat. Meanwhile, minerals in the water are cleansed off the beads by softening them naturally. And:

There are simple Pelican water softener review tips for you to follow when doing water softener maintenance. First, check the level of sodium in your water. If it is too high, then have the water tested. It could be that your supply is heavily contaminated or that you are using a dirty filter. Have your filter replaced immediately. Salt deposits can accumulate on both the inside and outside of your filter, so once this accumulation is removed, you will get softer water.

Use salt pellets during water softener maintenance. This is particularly beneficial for hard water, especially if you live in a dry, hot area. When there is too much salt in your tank, it can cause the level to rise above normal levels. Therefore, you will get softer water by removing salt from the brine tank.

You can also use the brine tanks as a salt bridge. If you have hard water, but you are installing a salt bridge, this will also work to fix the problem. You can do this by placing the salt bridge next to the softening element and then filling the softening tank up with the brine water. The brine tank will act as a buffer, holding back the excess salt in the tank. This should solve your problems.

Another way to clean your water softener is to simply drain it. But first you need to ensure that the pipes inside the tank are clean and clear. Then open the valve for draining the water. Lastly, you should clean the salt bridge by pouring boiling water over it. To remove hard mineral stains, you can also use some baking soda and salt.

There is one thing to note when doing water softener maintenance on a home or commercial property. You need to be careful not to let any water pass through the prefilter. Otherwise, you will risk having rust starting on the part that is close to the water supply pipe. Rust, along with calcium, can clog the pipes inside the prefilter, which will prevent water from passing through at all. If your system uses salt, there are chances that you could have water coming out of the pipes. In such cases, you can clean the salt off by using coarse sandpaper.

Performing regular cleaning rituals will help you reduce water softener cost by a significant margin. It is better to spend some money and invest in a good brine tank rather than spending money on regular cleaning rituals that do not guarantee you any results. Spending a little more for a good water softener unit is worth it, compared to the costs of not having a reliable and durable unit. For example, salt water softener requires regular replacement of the salt, which is very expensive. On the other hand, a good brine tank only requires less maintenance and replacement of salt once in a few years.

For more information please visit https://www.watersoftenersolutions.com/pelican-water-systems/.

Author's Bio: 

A water softener works by using an ion-exchange method. In a water softener, water is circulated down through the resin bed where it is softened.