6 Steps To Replace The Heating Element In An Electric Oven

An oven is immensely useful for doing multiple chores. From baking delicious titbits to heating a cup of water, it does it all! Thus the heating element is an essential part of an oven! If you are facing issues with the heating element then follow these steps to replace it right away:

Tools and materials that you will need:

• A screwdriver
• A non-contact voltage tester
• A baking coil element specific to your oven model
• Needle nose pliers
• A nut driver
• An electrical or masking tape

Step 1: Unplug from the electrical supply:

In case you fear the start of such replacement steps then do not hesitate to contact the specialists doing oven repairs in Coomera. You must make sure to that all the oven or range controls are off. Unplug the oven from the sockets and in case of freestanding ranges the cord is usually accessible on removal of the bottom drawer.

In case you cannot reach the cord then turn off the oven's circuit breaker in your home's circuit breaker box.

Step 2: Removal of heating element mounting plate:

Seek the example of professionals doing Haier oven repairs in Gold Coast and begin by the initial steps. Locate the baking heating element and the bracket that holds it in the destined position. Open the oven and remove all the oven racks. Remove the screws securing the mounting plate to the oven wall with the aid of a screw driver.

Step 3: Test the electrical connectivity:

The professionals undertaking the Maytag oven repairs in Gold Coast always make sure that the electrical connectivity is temporarily disconnected. It is always better to be safe than sorry so gently pull the heating element and the bracket away. Confirm that the circuit power is off by using a non-contact voltage tester to test the exposed wires.

Step 4: Disconnect the heating element:

The experts doing Haier oven repairs in Brisbane are adept at disconnecting and removing the old heating element. Since you are a novice so being careful as you disconnect the wire connector from the heating element is crucial! Use needle nose pliers and avoid using your fingers at all costs. Temporarily tape the wires while removing the old heating element from the oven.

Step 5: Installation of the new heating element:

All you need to do is just reverse the disconnection process used to remove the faulty part. Use pliers to force the wire connectors onto the probes while installing the new oven element. Ensure that the mounting bracket is against the oven wall and screw holes are aligned.

Step 6: Reattach the mounting plate and test the oven:

To complete the heating element replacement and oven repairs in Logan like a pro, secure the mounting plate and drawer back. Plug it back and turn it to bake, if you see bright orange light then congrats you have made a successful replacement!

The bottom line: The electric ovens usually range around 240V and consumes up to 50 amps of electric power. It is always a better option to leave such hazardous chores to the professionals!